I have been trying to set up flaps on my plane for at few days now, but i can't figure it out. I have the following configuration : Transmitter : Futaba T10J. Receiver : R3008SB/FHSS (mode 1 / eight channel configuration) Plane :Multiplex Fun Cup. 1 Servo for Elevator. 1 Servo for Rudder. First in the port tab, enable “Serial RX” in the UART you have chosen for SBUS. And select SmartPort as the Telemetry Output option in the UART you have chosen for SPort. Go to Configuration Tab, and under Receiver, choose the following options. Finally, turn on “Telemetry” feature under “Other features”. Use only the Futaba lithium ion transmitter charger included with this set for, or other chargers approved by Futaba to charge the Li-Ion batteries in the 1 Z transmitter. Page 8 AT THE FLYING FIELD Always pay particular attention to the flying fields’ rules, as well as the presence and location of spectators, the wind direction, and any Futaba transmitter manual for instructions on reversing the throttle channel. Transmitter and Receiver Binding Binding Procedure Reference Table 1. Refer to your transmitter instructions for binding to a receiver. 2. Make sure the fl ight battery is disconnected from the aircraft. 3. Ensure the transmitter is powered OFF. 4. #simulator #rcsimulator #rcflightsimulator #setup #flyskyFS-i6 #howtointallrcsimulator #channelmappingSupport Me:Buy Me Coffee: That is done in the SYSTEM > TRAINER function. 2.2. In the same TRAINER function on the Master transmitter you MUST go to page 4/4 and change ACT from INH to OFF, then select the desired switch. Note that ACT will not change from OFF until you connect the Slave transmitter AND engage the switch you selected. Bricks is quite right its impossible to set up flapperons with a Y harness. You need to split the ailerons: ail lead 1 to ch2 and ail lead 2 to ch6, set them up first as independent ailerons on your transmitter ensuring that they operate in the correct directions (may require reversing in the transmitter, or even the leads swapping over on the reciever). TAWAN-REVIEW: How to set 2 servo for Elevator, P.Mix by Futaba T10J#P_Mix #Futaba_T10J#TawanReview App Vay Tiền Nhanh.

how to set up futaba transmitter